Six Easy Steps In Cleaning Your Inline Skate Bearings

Clean bearings roll smoother, are faster and will last longer than dirty bearings. Grit and sand can trigger tiny pits in the balls and produce an uneven rotation.

Beneath are instructions on the best way to clean a bearing with a removable shield. If the shield on your bearings are stationary, ignore the actions which are directed to removing shields.

Should you clean and lubricate your bearing frequently they should last you a lengthy time. Always steer clear of acquiring your bearings wet, and keep them free of sand! Clean and lubricate skate bearings right away if they become wet.

Tools You may Need:

• Small bowl or metal pan
• Straight pin
• Bearing cleaner
• Small cleaning brush such as a toothbrush. Soft or medium, nothing too tough!
• Clean towels
• Paper Towels

1. For removable shields: Insert the end of the straight pin into the end of the C-ring which holds the shield onto the bearing body. Very gently pry the C-ring up and towards the center of the bearing, operating your way around the circle. Get rid of the shield slowly, often taking care not to damage it.

2. Place bearing in container or bowl and flush with bearing cleaner to eliminate contaminants. Citrus cleaners perform properly. Use the tiny brush or toothbrush and get rid of bigger pieces of dirt and grime. If your bearings are especially dirty, you could have to repeat this step. Be sure to change your solvent with every rinsing.

3. Right after you have cleaned the bearing, pat it gently dry with a clean, lint free towel. Location on a paper towel and enable it to air dry. Ensure that all water has evaporated and dries out totally prior to proceeding towards the subsequent step.

4. Right after the bearing has completely dried, apply 1 to 2 drops of quality lubricant to the inside of the bearing. A bit lubricant goes a lengthy way. Rotate the bearing slowly to perform the lubricant in to all the moving parts. Ensure the balls are completely covered in oil/grease.

5. Replace the shield by placing it on top of bearing and slipping the C-ring into the groove next towards the shield. Then function remaining length of C-ring slowly and gently around the fitted groove until it snaps back into location.

6. Put your freshly cleaned bearings back on your skates and spin them to insure oil/greases is evenly distributed and wheels are spinning smoothly.

Warning: Usually use extreme caution whenever operating with any cleaning solvent. Bearing Cleaner is really a toxic chemical and should be washed off skin instantly.